Teldat bintec RT1202 Bedienungsanleitung PDF herunterladen (Seite 255)

100

101

Field Description

• ' (default value): RIP is not enabled.

• @ 6: Enables sending and receiving of version 1 RIP

packets.

• @ 6: Enables sending and receiving of version 2 RIP

packets.

• @ 656:Enables sending and receiving RIP packets of

both version 1 and 2.

• @ 6 ( : RIP V1 messages are sent, received

and processed as per RFC 2091 (triggered RIP).

• @ 6 ( : RIP V2 messages are sent, received

and processed as per RFC 2091 (triggered RIP).

Route Announce Select this option if you want to set the time at which any activ-

ated routing protocols (e.g. RIP) are to propagate the IP routes

defined for this interface.

Note: This setting does not affect the interface-specific RIP con-

figuration mentioned above.

Possible values:

• 0)  . (not for LAN interfaces, interfaces in Bridge

mode and interfaces for leased lines): Routes are propagated

if the interface status is up or ready.

• 0) ,& (default value): Routes are only propagated if the

interface status is up.

• -,1&#: Routes are always propagated independently of op-

erational status.

15.1.2 RIP Filter

In this menu, you can specify exactly which routes are to be exported or imported.

You can use the following strategies for this:

• You explicitly deactivate the import or export of certain routes. The import or export of all

other routes that are not listed is still allowed.

• You explicitly activate the import or export of certain routes. In this case, you must also

explicitly deactivate the import or export of all other routes. This is achieved using a filter

for IP Address / Netmask = no entry (this corresponds to IP address 0.0.0.0 with net-

mask 0.0.0.0). To make sure this filter is used last, it must be placed at the lowest posi-

Teldat GmbH

15 Routing Protocols

bintec Rxxx2/RTxxx2 241

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 621 622

Kommentare zu diesen Handbüchern

Keine Kommentare

Teldat bintec RT1202 Bedienungsanleitung Seite 255

Kommentare zu diesen Handbüchern