Teldat bintec W1002n Bedienungsanleitung Seite 361
- Seite / 554
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
• L2TP LNS Mode (L2TP Network Server): for incoming connections only
• L2TP LAC Mode (L2TP Access Concentrator): for outgoing connections only
Note the following when configuring the server and client: An L2TP tunnel profile must be
created on each of the two sides (LAC and LNS). The corresponding L2TP tunnel profile is
used on the initiator side (LAC) to set up the connection. The L2TP tunnel profile is needed
on the responder side (LNS) to accept the connection.
16.2.1 Tunnel Profiles
A list of all configured tunnel profiles is displayed in the VPN->L2TP->Tunnel Profiles
menu.
16.2.1.1 New
Choose the New button to create additional tunnel profiles.
Fig. 148: VPN->L2TP->Tunnel Profiles->New
The menu VPN->L2TP->Tunnel Profiles ->New consists of the following fields:
Teldat GmbH
16 VPN
bintec WLAN and Industrial WLAN 347
- Reference 1
- Legal Notice 2
- Manual Teldat GmbH 2
- Table of Contents Teldat GmbH 10
- Table of Contents 11
- Chapter 1 Introduction 15
- 1 Introduction Teldat GmbH 16
- Chapter 2 About this guide 17
- 2 About this guide 19
- Chapter 3 Installation 20
- 3 Installation 21
- Installation 22
- 3 Installation Teldat GmbH 22
- 3.1.2 Connectors 23
- 3.1.3 LEDs 24
- 3.1.4 Scope of supply 25
- 3.1.6 Reset 27
- 3.2 bintec W1002n 28
- 3.2.2 Connectors 31
- 3.2.3 Antenna connectors 32
- 3.2.4 LEDs 32
- 3.2.5 Scope of supply 33
- 3.2.7 Reset 35
- 3.3.2 Connectors 39
- 3.3.3 Antenna connectors 40
- 3.3.4 LEDs 40
- 3.3.5 Scope of supply 42
- 3.3.7 Reset 46
- 3.4.2 Connectors 50
- 3.4.3 Antenna connectors 51
- 3.4.4 LEDs 52
- 3.4.5 Scope of supply 53
- 3.4.7 Reset 56
- 3.5 Cleaning 57
- 3.6 Pin Assignments 57
- 3.6.2 Serial interface 59
- 3.6.3 Socket for power supply 59
- 3.7 Frequencies and channels 60
- 3.8 Support information 60
- 3.9 WEEE information 61
- Chapter 4 Basic configuration 62
- 4.1.2 Software update 63
- 4.2 System requirements 64
- 4.3 Preparation 64
- 4.3.2 Configuring a PC 66
- 4.4 IP configuration 67
- GUI Call up 69
- 4.5 Modify system password 70
- 4.7 Setting up a bridge link 71
- 4.8 Software Update 73
- 5.1 Access Options 74
- 5.1.1.2 Telnet 75
- 5.1.1.3 SSH 75
- 5 Access and configuration 75
- 5.2 Login 79
- 5.3 Configuration options 80
- 5.3.1 GUI for advanced users 81
- 5.3.1.1 Calling up GUI 82
- 5.3.1.2 Operating elements 82
- Fig. 37: Filter list 88
- 5.3.1.3 GUI Menus 90
- 5.4 BOOTmonitor 91
- Fig. 38: BOOTmonitor 92
- Chapter 7 System Management 94
- 7.2 Global Settings 97
- 7.2.2 Passwords 100
- 7.2.3 Date and Time 101
- ISDN/Manual 102
- Time server 102
- Teldat GmbH 103
- 7 System Management 103
- 7.2.4 System Licences 106
- 7.2.4.1 Edit or New 107
- Routing versus bridging 108
- 7.3.1 Interfaces 110
- 7.3.1.1 Add 111
- 7.4 Administrative Access 113
- 7.4.1.1 Add 114
- 7.4.2 SSH 115
- 7.4.3 SNMP 119
- 7.5 Remote Authentication 120
- RADIUS packets 121
- 7.5.1.1 Edit or New 122
- 7.5.2 TACACS+ 126
- 7.5.3 Options 129
- 7.6 Certificates 130
- 7.6.1 Certificate List 131
- 7.6.1.2 Certificate Request 134
- 7.6.1.3 Import 139
- 7.6.2 CRLs 140
- 7.6.2.1 Import 141
- 7.6.3 Certificate Servers 142
- Chapter 8 Physical Interfaces 143
- 8.2 Serial Port 145
- 8 Physical Interfaces 147
- 8.3 Relay 149
- Chapter 9 LAN 151
- Example of subnets 152
- 9.1.1.1 Edit or New 152
- 9 LAN Teldat GmbH 152
- 9.2 VLAN 155
- 9.2.1 VLANs 157
- 9.2.2 Port Configuration 158
- 9.2.3 Administration 158
- Chapter 10 Wireless LAN 160
- 10.1 WLAN 161
- 10 Wireless LAN Teldat GmbH 162
- 10 Wireless LAN 163
- Setting network names 176
- Security measures 178
- 10.1.2.1 Edit or New 178
- 10.1.3 WDS Links 185
- 10.1.3.1 Edit or New 186
- 10.1.4 Client Link 188
- 10.1.4.2 Client Link Scan 190
- 10.1.5 Bridge Links 191
- 10.1.5.1 Edit or New 197
- 10.1.5.2 Bridge Links Scan 198
- 10.2 Administration 200
- 11.1 Wizard 201
- 11.1.1 Basic Settings 202
- 11.1.2 Radio Profile 203
- 11.1.3 Wireless Network 203
- 11 Wireless LAN Controller 205
- 11.2 Controller Configuration 207
- 11.3 Slave AP configuration 209
- 11.3.1 Slave Access Points 210
- 11.3.1.1 Edit 211
- 11.3.2 Radio Profiles 214
- 11.3.3.1 Edit or New 221
- ->New 222
- 11.4 Monitoring 228
- 11.4.3 Load Balancing 229
- 11.4.4 Neighbor APs 230
- 11.4.5 Rogue APs 231
- 11.4.6 Rogue Clients 232
- 11.5 Maintenance 233
- Chapter 12 Networking 236
- 12 Networking 237
- 12 Networking Teldat GmbH 238
- 12.1.2 IPv4 Routing Table 242
- 12.1.3 Options 243
- 12.2 NAT 244
- 12.2.2 NAT Configuration 246
- 12.3 Load Balancing 252
- 12.3.2.1 Edit or New 257
- 12.4 QoS 260
- 12.4.2 QoS Classification 263
- 12.4.3.1 New 267
- 12.5 Access Rules 273
- 12.5.1 Access Filter 275
- 12.5.2 Rule Chains 279
- 12.5.3 Interface Assignment 280
- 12.5.3.1 Edit or New 281
- 12.6 Drop In 282
- Chapter 13 Routing Protocols 286
- 13 Routing Protocols 287
- 13.1.2 RIP Filter 288
- 13.1.2.1 New 289
- 13.1.3 RIP Options 291
- Chapter 14 Multicast 294
- 14.1 General 295
- 14.2 IGMP 296
- 14.2.1 IGMP 297
- 14 Multicast Teldat GmbH 298
- 14.2.2 Options 299
- 14.3 Forwarding 301
- 14.4 PIM 302
- 14.4.1.1 Edit or New 303
- 14 Multicast 303
- 14.4.2 PIM Rendezvous Points 306
- 14.4.3 PIM Options 307
- Chapter 15 WAN 309
- Authentication 310
- Default Route 310
- Activating NAT 310
- Connection Idle Timeout 310
- 15.1.1 PPPoE 311
- 15 WAN Teldat GmbH 312
- 15.1.2 PPTP 316
- 15.1.3 IP Pools 321
- 15.2 Real Time Jitter Control 322
- 15.2.1.1 New 323
- Chapter 16 VPN 324
- 16.1.1 IPSec Peers 325
- Peer Monitoring 326
- 16.1.1.1 New 326
- 16 VPN Teldat GmbH 326
- 16.1.2 Phase-1 Profiles 341
- 16.1.3 Phase-2 Profiles 349
- 16.1.4 XAUTH Profiles 354
- 16.1.5 IP Pools 356
- 16.1.6 Options 357
- 16.2 L2TP 360
- 16.2.1 Tunnel Profiles 361
- 16.2.2 Users 364
- 16.2.3 Options 370
- 16.3 GRE 371
- 16.3.1.1 New 372
- Chapter 17 Firewall 374
- IP Access Lists 375
- 17.1 Policies 375
- 17.1.1.1 New 376
- 17 Firewall Teldat GmbH 376
- 17 Firewall 377
- 17.1.2 QoS 379
- 17.1.3 Options 380
- 17.2 Interfaces 382
- 17.3 Addresses 383
- 17.3.2 Groups 384
- 17.4 Services 385
- 17.4.2 Groups 387
- Chapter 18 Local Services 389
- 18 Local Services Teldat GmbH 390
- 18.1.1 Global Settings 391
- 18.1.2 DNS Servers 393
- 18.1.3 Static Hosts 395
- 18.1.4 Domain Forwarding 396
- 18.1.4.1 New 397
- 18 Local Services 397
- 18.1.5 Cache 398
- 18.1.6 Statistics 399
- 18.2 HTTPS 400
- 18.3 DynDNS Client 401
- 18.3.2 DynDNS Provider 403
- 18.4 DHCP Server 405
- 18.4.2 DHCP Configuration 406
- 18.4.2.1 Edit or New 407
- 18.4.3 IP/MAC Binding 410
- 18.4.4 DHCP Relay Settings 411
- 18.5 Scheduling 412
- 18.5.1 Trigger 413
- 18.5.2 Actions 418
- 18.5.3 Options 429
- 18.6 Surveillance 430
- 18.6.2 Interfaces 433
- 18.6.3 Temperature 434
- 18.6.3.1 Edit or New 435
- 18.6.4 Ping Generator 436
- 18.7 Teldat Discovery 437
- 18.8 HotSpot Gateway 440
- Requirements 441
- 18.8.1 HotSpot Gateway 442
- 18.8.2 Options 446
- Chapter 19 Maintenance 447
- 19.1.2 DNS Test 448
- 19.1.3 Traceroute Test 448
- 19.2.1 Options 449
- Configuration file format 450
- 19 Maintenance Teldat GmbH 450
- 19 Maintenance 451
- 19.3 Reboot 455
- Chapter 20 External Reporting 456
- 20.1.1.1 New 457
- 20 External Reporting 457
- 20.2 IP Accounting 459
- 20.3 Alert Service 461
- 20.3.2 Alert Settings 464
- 20.4 SNMP 466
- 20.4.2 SNMP Trap Hosts 467
- 20.5 Activity Monitor 468
- 20.5.1 Options 469
- Chapter 21 Monitoring 471
- 21.2 IPSec 472
- 21 Monitoring 473
- 21.2.2 IPSec Statistics 474
- 21.3 Interfaces 475
- 21 Monitoring Teldat GmbH 476
- 21.4 WLAN 478
- 21.4.2 VSS 480
- 21.4.3 WDS 483
- WDS Link Details 484
- 21.4.4 Bridge Links 486
- Bridge link details 487
- 21.4.5 Client Links 488
- Client Link Details 489
- 21.5 Bridges 490
- 21.6 HotSpot Gateway 491
- 21.7 QoS 492
- 21.8 PIM 492
- 21.8.1 Global Status 493
- Glossary 501
- Glossary Teldat GmbH 502
- Index Teldat GmbH 542
Broyhill TRIBECA SECTIONAL Configurations manuels
Manuels d'utilisation et guides de l'utilisateur pour Meubles Broyhill TRIBECA SECTIONAL Configurations.
Nous fournissons des manuels en pdf 1 Broyhill TRIBECA SECTIONAL Configurations à télécharger gratuitement par type de document : Manuel de l'utilisateur
Kommentare zu diesen Handbüchern